Transom Washer Plates
Made of strong 3/8" 6061 T6 aluminum alloy (not cast aluminum), the CMC Transom Washer Plate can eliminate bolts "biting" into transoms and can more evenly distribute loads on high performance engines. Hole centers: Top Plate- 12-7/8"   Bottom Plate- 9-7/8"

Top Washer Plate (PN: 20022)
Shipping weight approximately 2 lbs.
$29
when ordered with a trim, lift or jack plate unit

Bottom Washer Plate (PN: 20032)
Shipping weight approximately 2 lbs.
$25
when ordered with a trim, lift or jack plate unit

Button Switch
This weatherproof trim button switch is made of molded black with raised white letters. It can easily be wired to the PT-130 Power Tilt & Trim or Power-Lift wire assemblies.

Button Switch (PN: 20220)
Shipping weight approximately 1 lbs.
$17
when ordered with a trim, lift or jack plate unit

Transom Wedges/Set-Back Spacers
These two degree wedges are designed to give extra positive or negative trim. The wedges are used as an aid for boats with an insufficient transom angle or for boats having planning problems at low speed. Our unique design of the CMC Transom Wedges allows you to also use them as set back spacers, by simply inverting 2, 4, or 6 sets. Hole design fits the same pattern as the Power-Lift transom bracket and standard motor mounting.(PN: 20122)

Transom Wedges/Set-Back Spacers (PN: 20122)
SIZE 1/2" X 4" X 11-1/4"
Shipping weight approximately 3 lbs.
$39
when ordered with a trim, lift or jack plate unit